BECKHOFF CP65xx - Manual (Page 17)

Installation Instructions
Fitting the Power Supply Cable
A 5-pin female plug connector with CAGE CLAMP connection and insertion
catches is supplied along with a snap-on strain relief housing in order to
assemble the PC power supply cable.
Female plug connector is
correspondingly coded This female plug connector is also coded at the factory, according to the
type of power supply fitted, so that the plug, when assembled, will fit the
Industrial PC's connecting socket.
Technical data Female plug connector
Number of contacts 5
Contact spacing 5 mm
Minimum conductor cross-section 1.5 mm²
Minimum conductor cross-section
(AWG)
16
Rated voltage (EN) 250 V
Rated voltage (CSA) 300 V
Current (EN) 16 A
Current (CSA) 15 A
Length of stripped conductor 8 to 9 mm
Materials for assembly of
the connector
Female plug connector
Strain relief housing
A
B
C D
Fitting the connector to the
cable
The plug is fitted to the cable as follows:
1. Strip insulation from the cable ends. Follow the technical data for
the female plug connector in the above table!
2. Push the conductors into their mountings, simply by pushing them
in as indicated on the pin assignment label.
3. Push the lower part (part A) of the strain relief housing (see
photograph on page 15) onto the top of the female plug connector
until it snaps into place.
4. Relieve the strain on the supply cable by fixing it in place with the
cable clamp (part C) and fixing screws (part D) (see photograph
below).
Applying the strain relief
Fix the upper part (part B) of the strain relief housing by snapping it onto
the lower part.
CP65xx 15