Bebe Confort Natural Comfort Electric Breast Pump - Manual (Page 22)

22
10- Troubleshooting
The motor does not function Check that:
• The USB cable and power cable are plugged in correctly. The buttons should illuminate briefly while plugging in the
power source. If it doesnt happen, try another power source.
• If the breast pump is on, push the button (1) Appendix I.
• If you are using battery power check that the batteries have been fitted correctly or have not run down (a red light
shows continuously for 20 seconds).
There is no suction or the suction is too
weak.
• Ensure that the sheild (I + J) is sealed on the breast perfectly and all parts of the breast pump have been assembled
correctly. The transparent diaphragm (E) is in position between the cover (B) and the bottle ring (C+D). See Annexe III.
• Check that the tube (H) is connected to the shield (I+J), the bottle ring (C) and the white o-ring (D) has been placed
on the bottle ring (B).
• The lid (B) and the bottle ring (C) should be firmly assembled and check that there is no sign of wear or damage.
• Re-start the appliance then press the lid (B). You are in the sittinf position.
The device loses power while running on
batteries.
Check that:
• Whether the red light is flashing as you express your milk. This indicates that you will need to replace the batteries or
recharge them before using the device again. Always keep new or recharged batteries near you.
Breast pain when expressing milk. • Use a lower level of suction. If the pain persists, speak to a breastfeeding adviser.
• Try different positions for shield (I + J).
• You can use a Bébé Confort plastic nipple to decrease the pressure on the nipple.
Little or no milk is produced. • Position the breast pump lower than your breast.
• Depending on the breast, the nipple could block the milk evacuation in the shield: if it happens, pause for several
minutes before recommencing.
• Follow the instructions for use, speak to a breastfeeding advisor if the problem persists.
Take care not to squash or kink the tube.
NB: A replacement parts kit (T) is supplied with the breast pump. The kit includes: a one-way valve (F) and two O-rings (D). We recommend
you replace the flexible internal shield, the tube and the nozzle as soon as you see any signs of wear (cracking, tears, etc.). Replacements are
available from your retailer. You should replace the tube after 6 weeks of use.
If you are unable to resolve a problem with the breast pump using the advice above, please phone the customer service department or email
us by going to the www.bebeconfort.com website, and clicking "Our Services" followed by "Contact us".
Bébé Confort has produced a breastfeeding guide packed with information and tips. It can be downloaded from www.bebeconfort.com.