Bebe Confort CabrioFix - Manual (Page 11)

20 21
EN
1 Shell
2 Belt buckle
3 a Crotch strap with belt pad
3 b Shoulder belts with belt pads
4 Slots to adjust shoulder belts
5 Support pillow
6 Carrying handle
7 Push button for adjusting carrying handle
8 Belt hook for lap section of safety belt
9 Rear belt hook for shoulder section of safety belt
10 Belt tensioner strap
11 Control button of the quick adjuster
12 Control button for removing car seat from
Bébé Confort frame
13 Belt hooks
14 Instuctions and airbag warning
sticker
15 Rim (for storing sun canopy)
16 Sun canopy (built-in)
17 Instruction manual
18 Storage compartment
19 Mounting bars for FamilyFix and EasyBase 2
Safety
General CabrioFix instructions
1. You are personally responsible for the safety of
your baby at all times.
2. Never hold your baby on your lap when driving.
3. Do not use the CabrioFix for more than 5 years.
4. Do not use second-hand products where the
history is unknown.
5. Replace the CabrioFix after an accident.
6. Read this instruction manual carefully and keep
it in the storage compartment in the CabrioFix.
Warning: Do not make any changes to the
CabrioFix whatsoever, as this could affect the
performance of the car seat and render
it unsafe.
CabrioFix maintenance instructions
1. The CabrioFix must undergo regular
maintenance. Do not use lubricants or
aggressive cleaning agents.
2. The cover, cushions and belt pads of the
CabrioFix can be removed in order
for these to be cleaned (also see washing
instructions). The flexible plastic edge can be
cleaned with water, soap and a soft cloth.
3. If the cover needs to be replaced at any time,
only use official fabrics.
EN
The CabrioFix and your baby
1. Never leave your baby unattended.
2. Always secure your baby with the harness belt.
3. Before every use, make sure the harness is not
damaged or twisted.
4. Make sure you can fit no more than one finger
between the harness and your baby (1cm).
5. Only use the support pillow of the CabrioFix
when the shoulder belts are in the lowest
position.
Warning: Never place the CabrioFix on an elevated
surface (such as a table or chair).
CabrioFix car use
1. Always check to make sure the car seat can be
installed properly in your car before purchasing
it.
2. Make sure that any fold-down rear seat is locked
into position.
3. Prevent the CabrioFix from becoming trapped or
weighed down by luggage, seats and/or
slamming doors.
4. Make sure that all luggage and other loose
objects are secure.
5. The safest place for your baby is the rear of your
vehicle, however if you need to install the seat in
the front passenger seat, please ensure that any
airbag is deactivated.
6. Only use a forward-facing seat that is fitted with
a 3-point safety belt that complies with the ECE
R16 standard (at a minimum).
7. Make sure the car safety belt buckle runs in a
straight line and stays below the belt hook of the
CabrioFix. See the p.8 example.
8. The car safety belt must be threaded along
all blue markings. For proper installation
instructions, see pages 8-9 and/or the sticker
on the side of the CabrioFix.
9. Always cover the CabrioFix when exposed to
direct sunlight in the car. Otherwise, the cover,
metal and plastic parts could become too hot for
your child’s skin.
Warning: The CabrioFix may only be installed in a
rear-facing position in the car.