Dynex DX-WGPUSB - Manual (Page 2)

2 Contents
Dynex DX-WGPUSB Wireless
LAN USB Adapter
Contents
Introduction ..................................................................................... 2
Installing the software and hardware .............................................. 2
Configuring the wireless network .................................................... 3
Troubleshooting ............................................................................... 6
FCC ................................................................................................... 6
Legal notices .................................................................................... 7
Français ....................................................... 8
Español ...................................................... 14
Introduction
Thank you for purchasing a Dynex Wireless LAN 802.11g Enhanced USB
adapter. This package contains:
• A Wireless LAN 802.11g Enhanced USB adapter
• A printed user guide
• A CD containing the wireless network adapter utility and drivers
and this user guide
If anything is missing, contact Dynex at (800) 305-2204.
Installing the software and
hardware
Use the following procedures to set up your wireless network.
To install wireless networking on a Windows XP computer:
Caution: Do not connect the USB adapter until instructed to do so.
1 Install the access point. For more information, see the access point
documentation.
2 Turn on your computer.
3 Insert the included CD in the optical drive.
4 If the installation program does not start automatically, use
Windows Explorer or My Computer to browse the CD and locate
the file named setup.exe, then double-click setup.exe to start
installing the software.
5 Follow the on-screen instructions to install the software.
6 Connect the USB adapter to a USB connector on your computer.
The Found New Hardware Wizard opens.
7 Click Install the software automatically (Recommended),
then click Next.
8 If a warning box opens, click Continue Anyway. Your computer
copies files to your hard drive.
9 Click Finish.
To install wireless networking on a Windows 2000 computer:
Caution: Do not connect the USB adapter until instructed to do so.
1 Install the access point. For more information, see the access point
documentation.
2 Turn on your computer.
3 Insert the included CD in the optical drive.
4 If the installation program does not start automatically, use
Windows Explorer to browse the CD and locate the file named
setup.exe, then double-click setup.exe to start installing the
software.
5 Follow the on-screen instructions to install the software.
6 Connect the USB adapter to a USB connector on your computer.
The Found New Hardware Wizard opens.
7 Right-click on the My Computer desktop icon, click Properties,
then click Hardware Device Manager. Make sure that the USB
adapter is listed as one of the devices in your computer.
8 If you are using Windows 2000, right-click on the Network
Neighborhood desktop icon, click Properties, then click Local
Area Connection's properties. The Local Area Connection
Properties dialog box opens.
DX-WGPUSB_combo.fm Page 2 Thursday, June 22, 2006 12:59 AM