Doro 820 - Manual (Page 5)

English
www.doro.com 5
Installation
Connection
1. Connect the mains adapter to the Y socket of the base unit and to an electrical
wall socket.
2. Carefully remove the battery cover from the back of the handset following the
diagrams below. Insert the battery plug and fi t the battery into the handset.
Replace the battery cover ensuring the lock tab is inserted correctly.
A) B) C)
3. Place the handset in the base unit, with the keypad facing outwards. Once the
handset is correctly placed in the base unit, a beep will be heard and the battery
charge indicator in the display will begin to fl ash.
4. Charge the handset battery without interruption for 24 hours initially (thereafter a
fully discharged handset battery will take up to 14 hours to recharge).
5. ONCE CHARGED, connect the telephone line cord to the socket marked T on
T T
the base unit and then to a telephone network wall socket.
6. A click will be heard when the modular plug is correctly connected.
7. To setup the answering machine (830R) please refer to pages 20-26.
Only for models with an extra handset (830R+1/820+1):
8. Connect the mains adapter to the Y socket of the charger pod and to an
electrical wall socket.
9. Carefully remove the battery cover from the back of the handset following the
diagrams above. Insert the battery plug and fi t the battery into the handset.
Replace the battery cover ensuring the lock tab is inserted correctly.
10. Place the handset in the charger pod with the keypad facing out and charge
the handset battery without interruption for 24 hours initially (thereafter a fully
discharged handset battery will take up to 14 hours to recharge).
11. ONCE CHARGED, if the range symbol in the display continually fl ashes please
refer to page 14, Register a New Handset or Base Unit .
IMPORTANT!
Under power failure conditions, this telephone will not operate. Please ensure that a separate telephone,
not dependent on local power, is available for emergency use. The earpiece of the handset may attract
small ferromagnetic objects such as staples and pins, care should be taken when placing the handset
near these items. Do not place the base unit in areas of high humidity or where it will be exposed to
direct sunlight or other major heat sources. Only use with the supplied power adapter.
D
й
й
й
N
iM
H