Doro 820 - Manual (Page 15)

English
www.doro.com 15
Settings
Type of Caller ID (CID)
Dependant on your network sytem requirements the Caller ID settings may need to be
adjusted. If the telephone has been purchased in Australia this setting will be displayed
as 1/4.
1. Press
w
.
2. Scroll using
< <
/
> >
until
w
fl ashes in the display. Press
0 0 0
3. Press
0
repeatedly until the display shows 1/5 - UK (1/4 - Australia).
0 0
4. Scroll using
< <
/
> >
to the desired setting:
1=BT for UK/Normal for Australia
2=CCA for UK/Polarity reversal for Australia.
5. Press
0
to confi rm setting and move to the next programming sequence, alternatively.
0 0
6. Press
w
to exit the Menu system.
Tone/Pulse Dialling (UK only)
Select dialling type (tone or pulse). The default setting is tone dialling, dependant on
your network system requirements this may not require changing.
This setting only applies to models purchased in the UK.
1. Press
w
.
2. Scroll using
< <
/
> >
until
w
fl ashes in the display. Press
0 0 0
3. Press
0
repeatedly until the display shows 2/5.
0 0
4. Scroll using
< <
/
> >
to the desired setting (TONE/PULSE). Press
0
to confi rm
0 0
setting and move to the next programming sequence, alternatively.
5. Press
w
to exit the Menu system.
Line Adaptation
On some telephone networks and PBX systems, it may be necessary to adjust the
microphone level.
If the telephone has been purchased in Australia this setting will be displayed as 2/4.
1. Press
w
.
2. Scroll using
< <
/
> >
until
w
fl ashes in the display. Press
0 0 0
3. Press
0
repeatedly until the display shows 3/5. - UK (2/4 - Australia).
0 0
4. Scroll using
< <
/
> >
to the desired setting (A/B=normal, C=medium, D=low).
> > > >
Press
0
to confi rm setting and move to the next programming sequence, alternatively.
0 0
5. Press
w
to exit the Menu system.