Baumatic BC392.2TCSS - Manual (Page 22)

22
Automatic ignition with flame failure safety device
To ignite a burner:
o
Press in the control knob of the
burner that you wish to light and
turn it clockwise to the maximum
position.
o
If you keep the control knob
depressed, the automatic ignition
for the burner will operate.
o
You should hold down the control knob for 20 seconds after the
flame on the burner has lit.
o
After this 20 second interval, turn the control knob to your
required setting between the maximum and minimum setting
symbols.
o
Once the burner is lit, turn the control knob to your required
setting between the maximum and minimum setting symbols.
o
To turn the burner off, turn the control knob fully anti-clockwise
to the gas off position.
o
In case of power failure, the burners can be lit by carefully using
a match.
Energy saving tips
PANS BURNERS
Minimum
diametre
Maximum
diametre
Wok 220 mm 260 mm
Rapid 180 mm 260 mm
Semi-rapid 140 mm 260 mm
Auxiliary 120 mm 140 mm
o
The diametre of the bottom of the pan should correspond to that
of the burner.