Clearing a jam from the tool – DeVillbiss Air Power Company 2by4 Contractor Series User Manual
Page 13
PAGE 13
Disconnect tool from air compressor
before adjusting, clearing jams, servicing,
relocating and during non-operation.
FASTENER JAMMED IN FASTENER
DISCHARGE AREA:
1. Disconnect tool from air hose.
2. NF2502X4, NB1252X4, NB2002X4,
NBSNC2X4
Release the magazine latch to open the
magazine.
CLEARING A JAM FROM THE TOOL
Feeder
Magazine
Latch
Nose
Cover
Latch
SNC1002x4
Pull feeder shoe back into "locked" position.
3. Remove fasteners from magazine.
4. NF2502X4, SNC1002X4, NB2002X4, and
NB1252X4
Lift nose cover latch to unlatch and re-
move driver guide cover.
NBSNC2x4
Loosen the screws on the driver guide
cover and then remove the driver guide
cover.
5. Using pliers remove fasteners.
6. NF2502X4, NB1252X4, NB2002X4, and
SNC1002X4
Replace nose cover and latch into place.
NBSNC2X4
Replace nose cover.
7. Reload fasteners into magazine. Refer to
Loading the Tool section in this manual.