Dixon 539 132250 - Manual (Page 12)

12
ASSEMBLY
7 INSTALLING CHUTE SUPPORT
3 Bin System only
1. Position upper chute support against bagger
inlet, fl ush at outer edges. See Illlustration.
2. Using support as a template, drill two 3 /
8
" holes
into bagger hood.
UPPER CHUTE
SUPPORT
BAGGER INLET
NUT
BAGGER
HOOD
FLAT WASHERS
HEX BOLT
FLEX TRIM
3. Secure upper chute support to hood with hex
bolts, washers and nyloc nuts.
8 INSTALLING WEIGHT KITS
1¾ BOLT
2¾ BOLT
WEIGHT BRACKET
WEIGHT PLATES
1. Bolt weight plates to weight brackets using four
1¾" bolts and four nuts.
2. Slide both weight brackets over the front tube on
the frame, positioning the assembly in the center
of the frame.
3. Secure with four 2¾" bolts and four nuts.
2¾ BOLT
NUT
3¾ BOLT
WEIGHT BRACKET
CAST WEIGHT
1. Bolt one cast weight and two weight brackets
together using four 2¾" bolts and four nuts.
2. Slide both weight brackets over the front tube on
the frame, positioning the assembly in the center
of the frame.
3. Secure with four 3¾" bolts and four nuts.
Units with cast weight
FRONT TUBE
Units with two or more weight plates
RAM 44
RAM 50
FRONT TUBE