Resumption of service after storage, Table and torque of fasteners – Baja Motorsports DR49 Operator's Manual User Manual
Page 30
27
RESUMPTION OF SERVICE AFTER STORAGE
1. Remove the covering and remove the wooden blocks used in storing the
vehicle. Change the engine oil if the vehicle has been out of service for
over 4 months.
2. Drain off the remaining atomized anti-rust oil from the fuel tank, followed
by filling it with fresh gasoline therein.
3. Prior to driving, all the required check-ups must be made. It is better
to drive it at a low speed in an open area to test its performance before
normal operation.
TABLE AND TORQUE OF FASTENERS
Ser. No.
Fastener
Torque (Newton/m) (Foot/lb)
1
Front wheel axle nut
35-45Nm (26-33 ft.lb.)
2
Rear wheel axle nut
50-60Nm (37-44 ft.lb.)
3
Nut for tightening upper
joining plate of front fork
with vertical tube
40-50Nm (30-37 ft.lb.)
4
Nut for fixing engine
20-25Nm (15- 18 ft.lb.)
5
Rear arm nut
35-50Nm (26-37 ft.lb.)
6
Bolt for tightening upper
joining plate of front fork
with shock absorber
15-20Nm (11-15 ft.lb.)
7
Bolt for fixing footrest
20-25Nm (15-18 ft.lb.)