Baja Motorsports DR49 Operator's Manual - Manual (Page 19)

16
CHANGING THE OIL
1. Remove the screw plug located at the bottom of the engine and let the
oil drain into an approved collection container. DO NOT PERFORM THIS
PROCEDURE WHILE THE ENGINE IS HOT. SERIOUS BURNS COULD
RESULT FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures,
contact your local oil recycling center
3. Clean and replace the screw plug tightly.
4. Refill the engine with the proper amount of oil and recheck the amount of
oil in the engine by using the oil fill cap/dipstick.
CHECk-UP OF SPARk PLUG
1. Remove the cap of spark plug and
screw off the spark plug using the plug
wrench.
2. Clean the spark plug all around or
replace it if it is corroded or there is too
much deposit on it.
3. Regulate the gap of the spark plug to
0.6-0.8mm.
The spark plug of the designated type
should be used. The applicable type of
spark plug: A7RTC
0.6~0.8mm
Screw plug