Baja Motorsports AT250UT Operator's Manual - Manual (Page 25)

25 — English
MAINTENANCE
CLUTCH ADJUSTMENT
 Loosen the lock nut.
 Slowly rotate the adjusting bolt counterclockwise until
resistance is felt, then rotate 1/8 turn (45°) clockwise.
 Tighten the lock nut and torque to 10.8 ft.lb. (15 Nm).
DATE:
MODEL: DISPLACEMENT
: MADE IN CHINA
ENGINE MODEL: BRAND: CHONGQING RA
TO POWER CO., L
TD (ml)
Air filter removal and cleaning:

Remove the seat to gain access to the air filter box.
 Remove the air filter cover and set aside.
 Remove the air filter from the box.
 Remove the foam pre-filter from the paper air filter ele-
ment.
 Tap the air filter element gently to remove most of the dust
and dirt. Use compressed air to blow out remaining dust.
If the element is damaged, it should be replaced.
 Wash the foam pre-filter gently in water or a mild non-
flammable solvent.
 Squeeze out water and allow pre-filter to dry.
 Reinstall foam pre-filter over the paper air filter element.
 Replace the air filter element in the box. Make sure the
element is securely in position and the air filter is properly
sealed.
CAUTION:
Attempting to operate the ATV with a damaged or missing
o-ring will result in engine failure .
 Reinstall oil filter, o-ring if removed, and filter cap.
 Reinstall oil strainer, spring, and oil drainage bolt. Torque
oil drainage bolt to 18 ft.lbs. (13.3 Nm)
 Fill crankcase with specified lubricant as described at the
beginning of this section.
NOTE: Used lubricant should be disposed of at an approved
disposal site. See your local oil retailer for more informa-
tion.
CAUTION:
Attempting to start the engine before it has been properly
filled with lubricant will result in equipment failure.
CHECKING/CLEANING AIR FILTER
The air filter element must be kept clean to provide good
engine power. If you use your vehicle under normal, low-
tension conditions, you should service the air filter at the
intervals specified. If you ride in dusty, wet, or muddy con-
ditions, you will need to inspect the air filter element much
more frequently.
NOTE: Do not operate the engine without the air filter ele-
ments in place. Rapid engine wear will result.
CAUTION:
Always check the air filter element after riding in severe
conditions and clean or replace as needed. Operating
the ATV with a clogged air filter could cause engine
damage.
Checking the air filter:
There is a clear air filter check cap at the bottom of the air
filter case. If there is dust or water in this cap, empty the cap
and clean the air filter element and case.
LOCK NUT
BOLT