Baja Motorsports AT150SS Assembly Guide - Manual (Page 11)

11 — English © 2010 Baja, Inc. All Rights Reserved.
FINAL PREPARATION
VERIFY FLUID LEVELS
All fluids except fuel and appropriate engine lubricant are
filled at the factory. However, before attempting to operate
the unit, you should verify the correct levels of all fluids. When
checking fluid levels, make sure the unit is on a level surface
and the engine is off.
ADD GASOLINE
Add a small amount of gasoline to the unit for testing pur-
poses. Always use unleaded gasoline with a pump octane
rating of 87 or higher. Never use old, stale, or contaminated
gasoline, and do not use an oil/gas mixture. Do not allow dirt
or water into the fuel tank.
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) is acceptable. E85 is not.
COMPLETE PRE-DELIVERY INSPECTION
CHECKLIST
Verify that all items on the Pre-Delivery Inspection Checklist
have been completed as required. Keep this list for delivery
to the purchaser of this product.
ASSEMBLY
REINSTALLING BATTERY
 Lift up and remove the seat to expose the battery
compartment.
 Insert battery with poles facing forward.
 Insert the square washers through the side openings of
the battery poles.
 Attach red positive (+) cable to one of the bolts, and insert
the bolt through the positive (+) terminal on the battery.
Tighten securely.
 Attach black negative (–) cable to the other bolt and insert
the bolt through the negative (–) terminal on the battery.
Tighten securely.
 Reinstall seat and push down firmly to secure.