BAFO BF-5320 - Manual (Page 5)

2. Select the 'Driver' tab, then click the 'Update Driver' button.
3. Select 'Install from a list or specific location (Advanced)' and click 'Next'.
4. Make sure 'Search for the best driver in these locations' and 'Search
removable media (floppy, CD-ROM...)' are both selected and then click 'Next'.
5. As the installation process begins you may be presented with a dialog warning
about a non-logo'd driver, click 'Continue Anyway' to continue the installation.
6. If at the end of the installation process you are prompted to reboot the system
click 'Yes'.
7. See instructions in section 2.3 to verify controller was installed correctly.
2.7. Windows 98SE/ME installation
1. Power off the system. Insert Serial ATA 2 Port CardBus into an available
CardBus slot. Connect serial ATA cable(s) between the Serial ATA 2 Port
CardBus and the serial ATA device(s). Power up the system.
2. During the system boot up, the Hardware Wizard will display that it found a
'PCI RAID Controller', click 'Next'. Select 'Search for the best driver for your
device[Recommended]' and click 'Next'.
3. Make sure the 'CD-ROM drives' checkbox is checked and insert the Driver CD
into the CD-ROM drive. Click 'Next'.
4. System will go through the enumeration process and install the driver. At the
end of the process, click 'Finish' to complete the installation. Reboot the
system if your Windows 98SE/ME drive is connected on the SiI 3112 Controller.
5. See instructions in section 2.9 to verify controller was installed correctly.
2.8. Update driver on Windows 98SE/ME
With the Serial ATA 2 Port CardBus already plugged in and the driver already installed.
Follow the instructions below to update SiI 3112 driver.
1. Right click on 'My Computer' and select 'Properties'. Under 'System
Properties', click 'SCSI Controllers' then right click 'Silicon Image SiI 3112
SATALink Controller' and select 'Properties' from the context menu.
2. Click 'Driver', 'Update Driver' and select 'Automatic search for a better
driver[Recommended]'. Insert the Driver CD into the CD-ROM drive. Click
'Next' and complete the driver installation.
3. System will go through the enumeration process and install the driver. At the
end of the process, click 'Yes' to reboot your system.
4. See instructions in section 2.9 to verify controller was installed correctly.