Baby Lock Ellageo Plus (BLL2) Instruction and Reference Guide Addendum - Manual (Page 14)

12
Narrow hemmer foot
This foot is designed to curl under a 3 mm double hem
while sewing a straight stitch.
Narrow hemmer foot
■ Preparing to sew
a
Remove presser foot and attach snap-on
narrow hemmer foot.
b
Select the straight stitch (center needle
position).
c
Connect the foot controller so that both
hands are free to guide the fabric.
■ Sewing
a
Position the fabric (reverse side facing up)
under the presser foot. Lower the needle
3 mm from the edges of the fabric, lower the
presser foot, then sew 2 or 3 stitches.
b
Raise the needle and the presser foot, then
hold the ends of the upper thread and lower
thread to prevent them from being pulled out
of the fabric and pull the fabric out from the
front of the presser foot.
c
Holding both threads, pass them through the
curled part of the presser foot and pull them
toward the back of the presser foot. Wrap the
fabric around the curled part of the presser
foot in the same way. Position the edge of the
fabric just behind the needle and lower the
presser foot.
d
Without allowing the fabric to stick out from
the right side of the presser foot, lightly pull
on the thread while slowly sewing.
Reverse side Front side
3 mm
3
mm