Baby Lock Ellageo Plus (BLL2) Instruction and Reference Guide Addendum - Manual (Page 10)

8
a
Press to set the machine to free-motion
sewing mode.
→ The key appears as
, and the quilting foot is
raised to the necessary height for free-motion
sewing.
b
Select a stitch.
→ Free-motion open toe quilting foot “O” is indicated
in the upper-left corner of the screen.
c
Remove the presser foot holder.
d
Attach free-motion open toe quilting foot “O”
by positioning the pin of the quilting foot
above the needle clamp screw and aligning
the lower-left of the quilting foot and the
presser bar.
a Pin
b Needle clamp screw
c Presser bar
e
Hold the quilting foot in place with your right
hand, and tighten the presser foot holder
screw using the screwdriver with your left
hand.
a Presser foot holder screw
f
Use both hands to securely hold the fabric taut,
and then move the fabric at a consistent pace in
order to sew uniform stitches roughly
2.0-2.5 mm (approx. 1/16 - 3/32 inch) in length.
a Stitch
g
Press to cancel the free-motion sewing
mode.
Note
If using straight stitch needle plate with the free-motion
open toe quilting foot “O” then the letter “C” will be
indicated in the upper-left corner of screen.
Note
Make sure that the quilting foot is attached properly
and is not slanted.
CAUTION
• Be sure to tighten the screw securely with the
screwdriver. Otherwise, the needle may touch the
quilting foot, causing it to bend or break.
Memo
Do not be discouraged with your initial results. The
technique requires practice.
1
2
3