Avalon Firestyles 900 PI-1992 - Manual (Page 35)

PAGE 35
CARE & MAINTENANCE INSTRUCTIONS (Cont.)
G. EXHAUST DUCTS
(Cont.)
The next step is to remove the left or right
side exhaust duct:
Step 1 ¥ Lift the side exhaust duct up 1/4"
Step 2 ¥ Pull it towards the front of the
unit
Step 3 ¥ Tilt the bottom towards the
opposite side of the unit
Step 4 ¥Pull it through the door opening
Repeat these steps for removing the
opposite side exhaust duct.
Step 1 - Lift 1/4"
Step 2 -Pull
Towards Front
Step 3 - Tilt
Bottom Towards
Opposite Side
Step 4 - Pull Out Through Door Opening
Remove the lower exhaust duct to
complete the removal of internal firebox
components.
Remove the two rear exhaust clean-outs
by prying them loose with a screwdriver
(only on certain models). They are held
in place with expaninging metal clips that
are attached to the clean-outs.
Bend a piece of piano wire or other
similar wire into an "L" shape. Use this to
insert into the space behind the rear
exhaust clean-outs and remove any
blocking flyash. There should be very
little (if any).
Rear Exhaust
Clean-Outs
Then brush away any flyash that may have accumulated on the floor of the firebox or on the exhaust ducts with a brush.
Then vacuum or dump the flyash into a suitable disposal container.
H. HOPPER AND
AUGER TUBE
AREA
Vacuum the inside of the
hopper area and remove any
foreign objects that may have
wedged between the auger
flight and auger tube.
Auger Flight
Hopper
Auger
Tube
F r o
n t