Avalon Firestyles 900 PI-1992 - Manual (Page 33)

PAGE 33
CARE & MAINTENANCE INSTRUCTIONS
PRIOR TO CARRYING OUT MAINTENANCE, ENSURE THE APPLIANCE IS UNPLUGGED
AND HAS COOLED DOWN SUFFICIENTLY TO HANDLE THE PARTS WITH SAFETY.
A. HEAT EXHANGER TUBES
To clean the heat exhange tubes, push the built-in
cleaner located above the door back and forth a
couple of times.
Make sure to keep the door closed while doing this to
eliminate any flyash from coming out.
After performing this procedure, you may wish to
brush any loose flyash into the ash pan.
Built in
Cleaner
Handle
B. CERAMIC LOG SET (OPTIONAL)
Remove the ceramic log and log holder from the firebox and brush off any flyash that may have accumulated using a stiff
brush.
C. FIREBRICK
REFRACTORY
Remove the firebrick refractory by grasping it
on either side, lifting it up approximately 1/4 to
1/2", tilting it towards the front of the stove and
lifting it through the doorway out of the unit.
Brush away any flyash that may have
accumulated on the firebrick. Then vacuum or
dump the flyash into a suitable disposal
container.
Firebrick
Refractory
Firebrick Refractory Holder
D. FIREPOT AND HOLDER
Remove the firepot holder by pulling it towards the front of the unit while lifting up. Once the firepot holder is removed, the
firepot can be removed by pulling it straight up and out of the holder.
Brush away any flyash that may have attached to the bottom of the firepot or firepot holder. Then vacuum or dump the
flyash into a suitable disposal container.
Firepot
Firepot Holder