Delta 33-891 - Manual (Page 8)

8
ASSEMBLING
CUTTINGHEAD
TO TRACK ARM
1. Raise the track arm assembly (A) Fig. 7, by turning
overarm elevating handle (F) Fig. 2.
2. Remove packing material from around cuttinghead
assembly (B) Fig. 7.
3. Push track arm clamp lever (C) Fig. 7, to the rear until
it rests against stop (D) as shown.
4. Pull out on track arm index knob (E) Fig. 7, and rotate
track arm (F) 90 degrees to the position shown in Fig. 8.
Tighten track arm clamp lever (C) Fig. 8, by pulling it to
front position.
Fig. 7
Fig. 8
Fig. 9
Fig. 11 Fig. 10
5. Unscrew and remove blade guard clamping rod (G)
Fig. 9, and remove blade guard assembly (H).
6. Place cuttinghead clamp (J) Fig. 10, in slot on top of
cuttinghead. NOTE: Jaws of cuttinghead clamp must be
open as shown.
7. Lift cuttinghead assembly (B) Fig. 11, and insert
roller bearings (K) into track arm assembly (A) as shown.
NOTE: Make certain the roller bearings (K) are riding on
track rods (L). Push cuttinghead assembly (B) Fig. 11,
into track arm assembly (A) and tighten cuttinghead
clamp (J) Fig. 11.
C
D
A
F
E
B
C
F
G
H
J
A
J
L L K
B