ATI Audio MX100 - Manual (Page 3)

Audio Technologies Inc. | 154 Cooper Road #902 | West Berlin, NJ 08091 | Voice 856-719-9900 | Fax 856-719-9903 | www. audio.com
programmed for microphone level output.
A HEADPHONE switch selects either full program or split program and cue. A recessed,
thumbnail operated headphone level control minimizes panel clutter and once set, tracks
the MASTER output. A pre-fader cue from input one or an external director’s CUE
INPUT from a rear panel jack feed the headphone cue circuit thru an internal trimpot.
An EXPANSION INPUT to the mixing buss allows interconnection of two mixers or the
addition of one or more companion XP100 Mic/Line Input Expanders. All panel controls
and connectors are clearly labeled.
MX100, MX100C STUDIO MIXERS
Both the MX100 and the MX100C also provide three inputs with front panel selection of
microphone or line input levels. Phantom power and input stage gain is dipswitch
programmable for any input. Phantom power is disabled in the line input mode. The
MASTER level control feeds a high level output stage which comfortably drives either
balanced or unbalanced output loads of 600 ohms or greater. A bright LED VU meter and
headphone amplifier monitor the program output. The output may be set to line or
microphone level by moving an internal jumper plug. The MX100C adds a switched low
distortion compressor / limiter and a peak indicating LED to the basic MX100 Mixer. A
rear panel Expander input allows interconnection of two mixers or the addition of one or
more companion XP100 Input Expanders.
XP100 INPUT EXPANDER
The XP100 Input Expander provides an additional four MIC/LINE switchable inputs and
plugs into the Expansion Buss input of the mixer. 24V phantom power is available for
each input via internal jumper plug selection. The XP100 inputs provide a fixed 40dB
microphone gain and unity (0dB) gain for line inputs. The XP100 is supplied with
interconnecting expansion cables for the audio and DC connections to the MX101,
MX100 or MX100C.
POWER
A mixer and up to two companion XP100s can comfortably share a single external
WA100, 24VDC / 400mA. wall mount AC/DC power supply. A mixer and a single
expander can be powered from a DCA100 DC converter or a PPA-1 or 2 rechargeable
battery packs.
MOUNTING
Up to three amps will mount side-by-side in only one rack unit high using the available