Dimplex NBDF2608 - Manual (Page 7)

7
Fireplace Installation
WARNINg: Ensure the power
cord is not installed so that
it is pinched or against any
sharp edges and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
fire, electric shock or injury to
persons.
Electrical outlet wiring must
comply with local building
codes and other applicable
regulations to reduce the risk
of fire, electric shock and injury
to persons.
Do not attempt to wire your
own new outlets or circuits. To
reduce the risk of fire, electric
shock or injury to persons,
always use a licensed
electrician.
Figure 2 Figure 1
Foam
Block
Cable
Ties
Front
Glass
Trim
Track
Log Set
Assembly
Fireplace Assembly
The only assembly required is
to slide the Front Glass onto the
fireplace and install hardware to
keep it in place.
remove fireplace and glass 1.
carefully from the carton,
discard the plastic bag and
foam packaging.
remove the foam block from
2.
within the fireplace (Figure 1).
using side cutters or scissors,
3.
cut and remove the two (2)
cable ties as shown in Figure
1 and remove the cardboard
that protects the Log set
Assembly.
Remove the right hand side
4.
Trim by removing three (3)
Phillips screws at the side of