Installation, Powering up – ART Pro Audio Tube MP/C User Manual
Page 7
3
Installation
The Tube MP/C may be employed in a number of setups including:
•
Between a microphone and a mixer, digital workstation, or analog recorder.
•
In a mixer’s channel insert points.
•
Between a microphone and signal processors.
•
Between electronic musical instruments (synthesizers, guitars, bass, samplers, acoustic instruments with pickups)
and other gear.
The XLR output is transformer isolated allowing you to connect the outputs to two different systems without creating ground
loop noise.
Powering up
When the rear panel power switch is turned on, the power indicator LED will illuminate. It is important to remember to turn
the Tube MP/C on before any monitoring levels or power amps are turned on. The Tube MP/C has the ability to add over
60dB of gain to its input signal. This can cause the Tube MP/C to produce a “thump” on power up and power down. Note:
Like all tube-based equipment, the Tube MP/C needs to warm up before being used. Allow one to two minutes for the tubes
to reach proper operating temperature before using.
- 310 - 2way/3way Crossover (6 pages)
- CX311 - 2way Crossover with Subwoofer Out (12 pages)
- 405 - Five Zone Distribution Mixer (2 pages)
- 406 - Six Channel Headphone Amplifier (2 pages)
- 416 - Six Channel Mixer w/ EQ and EFX (2 pages)
- 418 - Eight Channel Mixer w/ EQ and Direct Outs (2 pages)
- HQ231 - Pro Dual 31 Band EQ w/ FDC (14 pages)
- Auto-Tune Pre (12 pages)
- CleanBOX II - Hum Eliminator (1 page)
- AV Direct - Audio/Video Direct Box (15 pages)
- CoolSwitchPro - Isolated A/B-Y Switch (16 pages)
- CLEANBox Pro - Dual Channel Level Converter (15 pages)
- CX310 - 2way/3way Crossover (12 pages)
- Pro MPA-II - Two Channel Mic Preamp (24 pages)
- DIO - A/D Converter (16 pages)
- DJPRE II - Phono Preamplifier (16 pages)
- dPDB - Dual Passive Direct Box (2 pages)
- DPS - DI/O Preamp System (20 pages)
- DPS II - Digital Preamplifier System (19 pages)
- DMV-Pro - Dual True-Stereo Effects Processor (61 pages)
- HeadAMP 4 - Eight Output Stereo Headphone Amp (14 pages)
- Dual Levelar - Two Channel Compressor/Limiter (6 pages)
- Dual MP - Two Channel Tube Preamplifier (7 pages)
- Dual Tube EQ - Two Channel, Tube EQ (19 pages)
- DUALZDirect - Dual Professional Passive Direct Box (15 pages)
- FX-1 - Personal Effects Processor (7 pages)
- EQ355 - Dual 31 band EQ (16 pages)
- HD-231 - Dual 31 band Graphic Equalizer (16 pages)
- HeadAMP V - Five Channel Mixer/Amplifier (1 page)
- HeadAMP 4 Pro - Five Channel Headphone Amplifier with Talkback (21 pages)
- HeadAmp6 - 6 Ch. Headphone Amp (12 pages)
- HeadAmp6 Pro - 6 Ch. Pro Headphone Amp (16 pages)
- HPFX - Headphone Mixer/Amplifier (12 pages)
- M-One/USB - Cardioid Condenser USB Microphone (2 pages)
- MX225 - MX225 Zone Distribution Mixer (2 pages)
- MX622 - 6 Ch (1U) Stereo Mixer w/ EQ/EFX Loop (2 pages)
- MX821 - 8 Ch (1U) Mic/Line Mixer w/ Tone (2 pages)
- MX624 - Six Channel Stereo Mixer (16 pages)
- P16 - XLR Balanced Patch Bay (8 pages)
- MX822 - 8-Channel Stereo Mixer with Effects Loop (12 pages)
- P48 - 48 Point Balanced Patch Bay (8 pages)
- SP4x4 PRO - LED Metered PDS (2 pages)
- PDB - Passive Direct Box (2 pages)
- PDB4 - 4-Channel Passive Direct Box (8 pages)
- Phantom I - Active Direct Box w/ Phantom Power (1 page)