ART Pro Audio SLA2 - 200W Power Amplifier - Manual (Page 16)

- 16 -
SLA-2 SPECIFICATIONS
Dimensions
1.75”H x 19.0” W x 13.5”D
Weight 19.8 lbs., 9.0kg.
Input Connections XLR,EUROBLOCK (balanced),
¼”TRS(balanced/unbalanced)
Output Connections
Multi-Way Binding Post
Input Impedance 44k ohms (balanced)
22k ohms (unbalanced)
Input Sensitivity
1V for Full Power Output into 8 ohms
Stereo Output Power, 8 ohms 200Watts RMS per Channel,
Stereo Output Power, 4 ohms 280Watts RMS per Channel
Bridged Output Power, 8 ohms 560Watts RMS mono
Stable into: 2 Ohms (stereo)
4 Ohms (mono)
CMRR
>60dB (typical @ 1kHz)
Frequency Response 10Hz to 40kHz, +/- .5dB
Hum and Noise >100dB below clipping
Total Harmonic Distortion (THD) <0.05% (typical)
Slew Rate >20V/uS
Damping Factor >100
Transformer Type Toroidal
Power Requirements 100VAC 50Hz 1000 WATTS (max.)
120VAC 60Hz 1000 WATTS (max.)
220VAC 50Hz 1000 WATTS (max.)
230VAC 50Hz 1000 WATTS (max.)
240VAC 50Hz 1000 WATTS (max.)
Export units configured for country of
destination.
ART maintains a policy of constant product improvement. ART reserves the right to
make changes in design or make additions to or improvements upon this product
without any obligation to install same on products previously manufactured. Therefore,
specifications are subject to change without notice.
Applied Research & Technology, a Division of Yorkville Sound
215 Tremont Street
Rochester, NY 14608 USA
(585) 436-2720
(585) 436-3942 (FAX)
www.artproaudio.com
© 2004 Applied Research & Technology