ART Pro Audio SDA1 - Studio Digital Amplifier - Manual (Page 14)

- 14 -
SDA-1 SPECIFICATIONS
Dimensions 1.75"H x 19.0" W x 9.5"D
Stereo Output Power, 8 Ohms 140 Watts RMS /Ch
Stereo Output Power, 4 Ohms 200 Watts RMS /Ch
Stereo Output Power, 2 Ohms 100 Watts RMS /Ch
Stereo Output Power, 16 Ohms 80 Watts RMS /Ch
Bridged Output Power, 8 Ohms 400 Watts RMS mono
Bridged Output Power, 16 Ohms 280 Watts RMS mono
Bridged Output Power, 4 Ohms 200 Watts RMS mono
Bridged Output Power, 70V line 280 Watts RMS 70Vline
Minimum Load Impedance 2 Ohms /Ch, 4 Ohms mono
CMRR >60dB (typical @ 1kHz)
Frequency Response 20Hz to 20kHz, +/- 0.5dB
Total Harmonic Distortion (THD) <0.05% (typical)
Hum and Noise A-weighted >95dB below Clipping
Input Sensitivity for full power 0.707 Volt
Idle current (120Volt AC Mains) 0.23 Amp (29 Watts)
Weight 7.5 lbs, 3.4 kg
AC Supply Type Digital Switching (~48 kHz)
Amplifier Type Digital Switching (~435kHz)
Overall Efficiency >78% @ full power
(4 & 8 Ohm operation)
Power
Requirements USA –90-125VAC 50-60Hz 875VA(max.)
EUROPE –230VAC 50Hz-60Hz 875VA(max.)
Export units configured for country of
destination.
ART maintains a policy of constant product improvement. ART reserves the right to
make changes in design or make additions to or improvements upon this product
without any obligation to install same on products previously manufactured. Therefore,
specifications are subject to change without notice.