ART Pro Audio DPS II - Digital Preamplifier System - Manual (Page 19)

- 19 -
DPS II  SPECIFICATIONS
Dimensions 1.75”H x 19”W x 6.5”D
Weight 5.5 lbs.
Analog Input Connections Front: XLR (balanced)/ ¼” (unbalanced)
Rear: Switchable XLR (bal.)/ ¼” TS,
Analog Output Connections XLR (balanced), ¼”TS,
Digital Input Connections ADAT Optical, Word Clock BNC
Digital Output Connections ADAT Optical/TOSLINK, S/PDIF RCA
Analog Input Impedance XLR –150 to 3K Ohms, ¼” -1M ohm
Analog Output Impedance XLR-300 ohms, ¼” -150ohms
Word Clock Specifications BNC jack, 5V max.,
Ext. sync mode source
Digital Level - ∞ to +10dB
Digital Output Specifications S/PDIF RCA 75 ohms, 0.5 Volt
Maximum Input Level +19dBu
Maximum Output Level, XLR +28dBu
Maximum Output Level, ¼”
+22dBu
CMRR >75dB (typical @ 1KHz)
Frequency Response 5Hz to 50KHz, +0.5dB
Dynamic Range >100dB
Total Harmonic Distortion <0.01% (clean), <0.1%(warm)
Maximum Gain
XLR to XLR 80dB
Inst. to ¼” 68dB
XLR to ¼” 74dB
Inst. to XLR 74dB
Equivalent Input Noise (EIN)
XLR to XLR -129dBu (A weighted)
Inst. to ¼” -105dBu (A weighted)
Tube Type 12AX7A, Dual Triode, Hand Selected
Power Requirements USA – 110-125V AC / 50-60hz/ 16W export
units configured for country of destination.
ART maintains a policy of constant product improvement. ART reserves the right to
make changes in design or make additions to or improvements upon this product
without any obligation to install same on products previously manufactured. Therefore,
specifications are subject to change without notice.