ART Pro Audio DPS - DI/O Preamp System - Manual (Page 19)

- 19 -
DPS
  SPECIFICATIONS
Dimensions
1.75”H x 19”W x 6.5”D
Weight 5.5 lbs.
Analog Input Connections Front: XLR (balanced)
Rear: Switchable XLR (bal.)/ ¼” TS,
Analog Output Connections XLR (balanced), ¼”TS,
Digital Input Connections
ADAT Optical, Word Clock BNC
Digital Output Connections ADAT Optical/TOSLINK, S/PDIF RCA
Analog Input Impedance
XLR, ¼” 5K ohms,1M ohm
Analog Output Impedance XLR, ¼” 300 ohms,150ohms
Word Clock Specifications BNC jack, 5V max.,
Ext. sync mode source
Digital Level -
∞
to +10dB
Digital Output Specifications S/PDIF RCA 75 ohms, 0.5 Volt
Maximum Input Level, XLR +19dBu
Maximum Input Level, ¼” +22dBu
Maximum Output Level, XLR +28dBu
Maximum Output Level, ¼” +22dBu
CMRR
>75dB (typical @ 1kHz)
Frequency Response 5Hz to 50kHz, +/-.1dB
Dynamic Range >100dB
Total Harmonic Distortion <0.01% (clean), <0.1%(warm)
Maximum Gain
XLR to XLR 80dB
¼” to ¼” 68dB
XLR to ¼” 74dB
¼” to XLR 74dB
Equivalent Input Noise (EIN)
XLR to XLR -129dBu (A weighted)
¼” to ¼” -105dBu (A weighted)
Tube Type 12AX7A, Dual Triode, Hand Selected
Power Requirements USA – 110-125V AC / 50-60hz/ 16W
Export units configured for
country of destination.