ARRIS SB6141 Quick Start Guide - Manual (Page 2)

© 2013 ARRIS Enterprises, Inc. All rights reserved.
ARRIS, SURFboard, and the ARRIS logo are all trademarks or registered trademarks of ARRIS Enterprises, Inc. Other trademarks and trade names may be used in this document to refer to either
the entities claiming the marks and the names of their products. ARRIS disclaims proprietary interest in the marks and names of others.
MOTOROLA and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used by ARRIS under License. All other product or service names are
the property of their respective owners. No part of the contents of this document may be reproduced or transmitted in any form or by any means without the written permission of the publisher.
594313-001-a 11/2013
ICON LED STATUS
Green (ON): Indicates power to the modem is properly connected
Green (ON): Indicates a downstream (receive data) channel
connection
Blue* (ON): Indicates a bonded downstream (receive data) channel
connection
Green (ON): Indicates an upstream (send data) channel connection
Blue* (ON): Indicates a bonded upstream (send data) channel
connection
Green (ON): Indicates Internet connectivity
Amber (ON): Indicates a device, computer, or router is connected
to the Ethernet port and is operating in Ethernet (10Base-T) or Fast
Ethernet (100Base-T) mode
Blue* (ON): Indicates a device, computer, or router is connected to
the Ethernet port and is operating in high-speed Gigabit Ethernet
(1000Base-T) mode
*
High-speed data service may not be available in your location. Check with
your service provider for more information.
Place Label Here
Please note: The SB6141 modem
label is also located on the bottom
of your modem. The label contains
specific ID information for your
modem.
To receive cable service, your
service provider may request
the Media Access Control (MAC)
address (see HFC MAC ID) and
serial number (see S/N) located
on the modem label.
Front Panel LEDs
Quick Start Guide
Modem Label
SURFboard
®
SB6141
DOCSIS ® 3.0 Cable Modem
During normal operation, the
POWER, RECEIVE, SEND,
and ONLINE LEDs should
always be ON. The LINK LED
should FLASH during data
transfer.
Note: During startup, all LEDs
will FLASH and then turn ON
in sequence. If an LED turns
ON and the next LED does
not FLASH, please contact
your service provider.