Argox R Series - Manual (Page 64)

64
8. Appendix
Printer Status
Blinking
LED Description
MEDIA The printer is at pause state. Press PAUSE or
CANCEL to return to normal state.
MEDIA
READY The media is uninstalled or used up. Load new
media to the printer.
RIBBON
READY The ribbon is uninstalled or end-of-ribbon
occurred. Load new ribbon to the printer. If you
just use thermal media set bit 1 of DIP switch to
OFF position.
READY The format or baud rate of the RS232
communication is inconsistent between the printer
and host.
The cutter can not cut off the media, check the
media and cutter.
The printer buffer is full caused by the loaded soft
fonts, graphics or forms. Check the format of
these data. Call for service.