Argox R Series - Manual (Page 28)

28
LED Indicators
There are three LED indicators on the front panel,
“READY”, “MEDIA” and “RIBBON”. These indicators
display the operation status of the printer.
READY The READY indicator will remain lighted except if
any of the following conditions prevail.
- Receiving data from host.
- A fault condition.
MEDIA The MEDIA indicator will remain on for the normal
operation of the printer.
- The printer is at PAUSE state.
- Blinking
– Media run out. (READY will be also
blinking.)
RIBBON ON I
– under thermal transfer mode with ribbon
installed.
OFF
– under direct thermal mode. (No ribbon
installed.)
Set by Windows driver or command.
Blinking
– Ribbon run out. (READY will be also
blinking.)
Notes:
1. We suggest you perform
“ media calibration “.
- for the first time media installation
- after change different type or size of media
2. After calibration, the printer will save the related parameters
(reflection characteristics, label length, etc.) to E
2
PROM.
Without calibration, the incorrect media/Gap detection may