Aplex Technology APC-3081 - Manual (Page 20)

APC-3081 User Manual 20
2.2.1 PWR1/PWR2
The power input of PCB was co-designed with PWR1or PWR2 for pre-selection。
PWR1 will use CJT brand like A3963WV-2P type connectors，PWR2 may use DINKLE brand like
DT-126RP-02P type connectors。PWR1/PWR2 are different housing design but same pin defined：
2.2.2 USB4/5
2.2.3 JP3
JP3 is designed for auto-on switch jumper with 2xPin-header as pitch 2.0mm type.
JP3 defaulted with closed jumper, system will be on when DC power input.
If JP3is open jumper, system power-on will be controlled by firmware of ASB-S700.
2.2.4 BAT1