Apantac MicroQ - Manual (Page 38)

MicroQ
APANTAC LLC, 7556 SW BRIDGEPORT ROAD, PORTLAND, OR 97224
[email protected] , TEL: +1 503 968 3000, FAX: +1 503 389 7921
37
Apendix I
Apantac eXchange Protocol - MicroQ
Revision Date: November 23, 2012
Introduction
The AXP-Lite is a set of text commands to allow 3
rd party interface to control the
Crescent MicroQ via TCP/IP.
Port Description
TCP/IP: Default port = 101
AXP-Lite Commands set Overview
Command FW
Release
Overview
audio Set audio monitoring output
Exit Exit from text command mode
ledumd Turn on/off tally and set label text
Load Load presets
AXP-Lite command sets
Audio: Set audio monitoring output
Note: MicroQ only supports 2 groups of embedded audio (8 channels), audio
monitoring must be done in pairs, therefore, when you choose meter 1, you
will get a stereo pair of 1 and 2, when you choose 3, you will get a stereo pair
of 3 and 4 and so on.
Audio [SDI_Number][GROUP] [Channel/PAIR]
Parameters Values Description
[SDI_Number] 1 - 4 SDI input number
[Group] 1 – 2
[Channel/Pair] 1 – 4 channel Pairs of audio meters
to be monitored