Amina iQ Developer Series - Manual (Page 8)

Cavity installation
Preparing the wall/ceiling and fixing the product
Typically a new build or full refurbishment /
Uses mounting blocks (sold separately)
01
02
Locate joist work
When you have chosen your speaker
locations, before cutting a hole in the
plasterboard it is important that you locate
the position of the joists/studs. Ensure the
spacing between them is at least 305mm
(12.01”) for a portrait orientated speaker.
Important: If the space in between joists is
less than 350mm (13
3/4 ”), consider using
the AIW350E/S200 loudspeaker which
only requires a 200mm (7
7/8 ”) wide cavity.
Create 405mm x 305mm aperture
Using a sharp knife or pad saw, cut an
aperture with dimensions 405mm x
305mm (18” x 13
3/4” ) in your plasterboard
wall or ceiling.
Ensure aperture is created between
supporting joists or stud work.
We strongly advise that joists are not
cut to make space for the product. Any
activity of this sort may well influence the
structural integrity of your property.
Important: Double check the size of the
aperture is 405mm x 305mm (15.95” x
12.01) as this is important further on into
the installation process.
305mm
(minimum)
cut a small
hole in plasterboard
to check stud location
01
02
sharp knife
pad saw
05
Cut-out Template
The supplied template may be
useful in marking the cut lines
A1