Amina iQ Developer Series - Manual (Page 10)

Cavity installation continued...
05
06
Connect the IQ Series speaker
Connect the speaker cable to the speaker
using a high quality crimping tool.
Your IQ Series speaker is fitted with blue
butt splice crimp connectors which are
suitable for speaker cable thicknesses of
1.5mm - 2.6mm (16 - 14AWG). This type of
connector ensures a permanent
“shake-proof” connection is created inside
your wall cavity.
Secure the speaker to the fixing blocks
Important: Ensure there is an all round
gap of 2mm between the speaker and the
plasterboard. If necessary, increase the
aperture size before mounting the speaker.
Using drywall screws, fix the four corner
points of the speaker to the fixing blocks.
Pilot holes are not necessary as drywall
screws will easily self-tap into the fixing
block.
Ensure the front face of the speaker rests
in a position flush with the front of the
plasterboard and that it is firmly held in
position.
Continue on to Section C
(page 18 - testing)
Reference pages for correct retrofit alignment and plastering method: 13, 14 + 15
Reference pages for correct drywall alignment and plastering method: 16 + 17
05
06
Top View
Plas
te
rboa
rd
Stud
Fixing block
2mm
screw through
here
07
2 2
A1