AMETEK ReFlex Firmware Updates - Manual (Page 6)

Technical Note
ReFlex Power™ Firmware Updates
Document No. M380570-01 Rev B • 1/23/2009
©2008 AMETEK Programmable Power, Inc. • All rights reserved. • AMETEK is a trademark of AMETEK, Inc.
9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email: [email protected] • Web: www.programmablepower.com
6 of 6
CAUTION
Factory service will be needed if incorrect files are loaded to the module.
Enter the correct Destination Chassis and Module(s).
Click the “Update” button under the Automatic Commands group.
The following message should appear; when ready click OK.
Your selections will automatically be validated then the download process will start.
During the update the BUS light on the module(s) will go from solid to off when addressed and the NET light on the controller will
flash.