Denso OFFICE PRO 36 - Manual (Page 9)

6
How to Set a Program
➀ Setting a START TIME
Press the Program SET button. The Program SET button and START TIME LEDs will
illuminate. Press the HRS and MIN buttons to set the START TIME.
➁ Setting an END TIME
Press the Program SET button until the END TIME LED illuminates. Press the HRS
and MIN buttons to set the END TIME.
➂ Setting the CLOCK TIME
Press the Program SET button until the SET CLOCK LED illuminates. Press the HRS ET CLOCK ET CLOCK
and MIN buttons to set the current clock time into the unit.
NOTE: The AM/PM LED will change with the HRS button.
➃ Programming the Temperature SET POINT
Press the Program SET button until the current SET POINT temperature display
begins to fl ash on and off. Select a new desired SET POINT temperature by pressing
the SET TEMP buttons (
▼ / ▲ ).
➄ Programming the Fan Speed
Press the Program SET button until one of the Fan Speed button LEDs (High/Low)
begin to fl ash. This is the current programmed Fan Speed. To change the pro-
grammed Fan Speed, simply press the other Fan Speed button.
➅ Exiting the Program SET Function
After changing any of the above settings, continue pressing the Program SET
button until the Program SET button LED turns off. The unit will then return to the
previous mode.
➆ Activating/Deactivating a Preset Program
Press the Program RUN button to activate/deactivate a preset program. The Program
RUN LED will illuminate when activated.
NOTE:
•
The unit will return to the previous mode if a program is turned off while it is
running.
• The Program RUN LED fl ashes while a program is running. It is illuminated con-
tinuously when the program mode is activated.
• While a program is running, the program can only be stopped by pressing the
Program RUN button. All other buttons are inoperable when a program is run-
ning.
• The unit returns to the previous mode at the end of a program.
• The unit does not have to be running to set a program.
• During programming, the unit returns to the previous mode if no activity occurs
within approximately 35 seconds.