Denso OFFICE PRO 36 - Manual (Page 8)

5
7. Temperature Scale LED - Illuminates to indicate
the current temperatures being displayed are
either in °C or °F; also used to display the clock
when programming.
8. AM/PM LED - Illuminates to indicate AM or PM
time of day.
9. Program RUN Button - Activates/deactivates a
program.
10. Program SET Button - Allows the user to pro-
gram the unit or check the current program.
11. START TIME LED, END TIME LED, SET
CLOCK LED - Illuminates to indicate the cur- CLOCK CLOCK
rent step that is being programmed into the
unit.
12. CLOCK/TIMER Buttons - Allows the user to set the clock and program the start and
end time of operation.
Operating in COOL Mode
➀ The unit can be operated in COOL mode by pressing the COOL
ON/OFF button (LED illuminates).
NOTE: In COOL mode the unit can only be turned off by pressing the “COOL ON/
OFF” button again, not by pressing the fan buttons.
➁ Change the fan speed by pressing the HIGH or LOW fan buttons.
➂ Change the temperature set point by pressing the SET TEMP buttons ( ▼ / ▲ ).
NOTE: When turning the unit on, the set point and fan speed are determined by the
last operating mode (program mode not included).
Operating in Fan Only Mode
➀ The unit can also be operated in Fan Only mode by pressing either the HIGH or LOW
fan buttons (LED illuminates).
➁ The unit can then be turned off by pressing the fan speed button that is illuminated.
Changing from Fan Only Mode to COOL Mode
➀ The COOL mode can be activated while the unit is operating in Fan Only mode. To do
this, simply press the COOL ON/OFF button (LED illuminates).
NOTE: The Fan Only mode will not operate after the COOL mode has been activated.
After the COOL mode has been activated, the unit cannot be turned off by pressing
SET TEMP CLOCK/TIMER
FAN ON/OFF
COOL ON/OFF PROGRAM
Office Pro 36
SET
START TIME
END TIME
SET CLOCK
RUN
HRS MIN
8 7
12
11
9
10
the fan buttons. The COOL ON/O N N FF button must be pressed. FF FF