Reflex power™ mating connectors for fpdc module, Interface connector, Interface pinout – AMETEK FPDC User Manual
Page 2: Optional interface connector accessories
Technical Note
ReFlex Power™ Mating Connectors for FPDC Module
Document No. W380274-01 Rev E
• 1/23/2009
©2008 AMETEK Programmable Power, Inc. • All rights reserved. • AMETEK is a trademark of AMETEK, Inc.
9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email:
• Web:
www.programmablepower.com
2 of 4
INTERFACE CONNECTOR
Connector: Positronic Industries P/N SD9M1000Z, AMETEK P/N 856-214-09
Crimp Contacts: Positronic Industries P/N MC7520D (initially supplied with connector)
Backshell: Positronic Industries P/N D9000Z00, AMETEK P/N 856-247-10
Wire size: Maximum gauge 20 AWG (22 AWG recommended)
Maximum length 10 meters.
INTERFACE PINOUT
Figure 2. Interface Connector, Front Panel View, and Interface Connector Wiring Diagram
Pin Signal
Description
1 ENAB
1
Enable module output
2 Reserved
3 Reserved
4 Reserved
5
CHAS GND
Chassis Ground
6 ENAB
RTN
1
Enable module output return
7 Reserved
8 Reserved
9 Reserved
1
Enable signal is internally pulled up to +5V with a 10 K resistor. To enable the module, the
signal is pulled low (<= 0.5V) with respect to the ENA RTN signal; this may also be
accomplished by shorting Pin 1 to Pin 6.
OPTIONAL INTERFACE CONNECTOR ACCESSORIES
•
AMETEK P/N 5380508-01, 9-pin Loop-back Connector Assembly, includes a jumper wire between Pins 1 and 6 to
enable the module outputs.
•
AMETEK P/N 5380448-01, Power Module, 9ft. Unterminated Interface Cable Assembly. Use when interfacing to an
external system.
•
AMETEK P/N 5380448-03, Power Module, Right Angle, 9ft. Unterminated Interface Cable Assembly. Use when
interfacing to an external system.