AMETEK LPDC-65V - Manual (Page 3)

Technical Note
ReFlex Power™ Mating Connectors for LPDC-65V Module
Document No. W380270-02 Rev E • 1/23/2009
©2008 AMETEK Programmable Power, Inc. • All rights reserved. • AMETEK is a trademark of AMETEK, Inc.
9250 Brown Deer Road, San Diego CA 92121 • Tel: 858-450-0085 • Fax: 858-458-0267 • email: [email protected] • Web: www.programmablepower.com
3 of 4
OPTIONAL INTERFACE CONNECTOR ACCESSORIES
• AMETEK P/N 5380508-01, 9-pin Loop-back Connector Assembly. Includes a jumper wire between Pins 1 and 6 to enable
the module outputs.
• AMETEK P/N 5380443-01, Power Module, 9ft. Unterminated Interface Cable Assembly. Use when interfacing to an
external system.
• AMETEK P/N 5380443-03, Power Module, Right Angle, 9ft. Unterminated Interface Cable Assembly. Use when interfacing
to an external system.
DC OUTPUT CONNECTOR
Connector: Positronic Industries P/N CBD13W6M2000Z, AMETEK P/N 856-214-07
Pins A1-A6: Positronic Industries P/N MS4820D-50, AMETEK P/N 856-745-53
Backshell: Positronic Industries P/N D37000Z00, AMETEK P/N 856-247-39
Wire size: Maximum gauge 20 AWG (recommended) (see table for length)
DC OUTPUT PINOUT
Figure 3. DC Output Connector, Front Panel View, and DC Output Connector Wiring Diagram
Pin Name Function Signal Level Maximum Wire Length, ft
A1 OUT
Output: module output source; connected to
A3 ±65V; ±300V,
maximum to chassis
40, for 1.5V line drop at 2.55A
A2 OUT-RTN
Output: return for output source, OUT;
connected to A4 ±65V; ±300V,
maximum to chassis
40, for 1.5V line drop at 2.55A
A3 OUT
Output: module output source; connected to
A1 ±65V; ±300V,
maximum to chassis
40, for 1.5V line drop at 2.55A
A4 OUT-RTN
Output: return for output source, OUT;
connected to A2 ±65V; ±300V,
maximum to chassis
40, for 1.5V line drop at 2.55A
A5 SNS Input: remote sense connection for OUT
±65V; ±300V,
maximum to chassis
40
A6 SNS-RTN
Input: remote sense connection for
OUT-RTN ±65V; ±300V,
maximum to chassis
40
4 CHAS-GND Shield ground Chassis ground 40
1-3,
5-7
- Reserved - -