Appendix e specifications – Aesthetix Atlas User Manual
Page 17
Appendix E
Specifications
17
Atlas Stereo
Inputs: Connectors:
1 Single-ended and 1 Balanced per channel for the Direct Input.
1 Single-ended and 1 Balanced per channel for the Crossover Input.
Input Impedance: Direct:
470 K
Ω Single-ended or Balanced for each phase.
Crossover:
Variable.
Input
sensitivity:
(Balanced)
2.3V RMS typical input for 200W into 8 ohms.
Gain:
(Balanced)
24dB.
Polarity:
(Single-ended)
Non-Inverting.
(Balanced) Pin-2 = Positive, Pin-3 = Negative for Non-Inverting Output.
Outputs:
Connectors:
1 balanced output per channel.
Impedance:
0.25 ohms @ 1KHz
Tubes
(2) -One 6SN7 or equivalent per channel.
I/O: RS232:
1 DB9 connector.
Modes/Processes:
Standby, High Pass Crossover.
Power Output:
(8 ohms) 200 W (rated) 250 W (typical at 1% THD, one Channel, 210W both channels driven)
(4 ohms) 400 W (rated) 410 W (typical, one channel driven)
Frequency Response:(-3dB points @ full power) 4 - 150 kHz.
THD+Noise:
<1.0% (both channels driven at 200W into 8 ohms).
Power Consumption: 100W @ Standby,150W @ Idle
Trigger Inputs:
1/8” Jack, operates on either 5-12 VDC Pulse < 100mS or 5-12V DC.
Dimensions:
17
7/8
” W x 7
1/2
” H x 18" D (454 x 191 x 457 mm)
Weight:
70 Lbs. Stand alone (32.67 Kg), 80 Lbs. Boxed with accessories (36.29 Kg)
Maximum Operating Internal:
176
° F (80° C)
Temperature: Room:
122
° F (50° C)
Fuses:
Mains:
10A SB @ 100, 117VAC
5A SB 230, 245VAC
Power Supply: 2A SB @ 100, 117V AC
1A SB 230, 245VAC
Audio Outs:
10A FB.
Specifications subject to improvement or change without notice.