Aervoe Solar Link 1000 - Manual (Page 9)

9
CARE AND MAINTENANCE
• Dust regularly with a clean dry cloth to prevent dust and dirt from building up on the vents and
power inputs/outputs
• Store in a clean, dry place when not in use
• Charge after each use, every 4-6 months, and before storing so it is ready to use when needed
• Turn the INVeRTeR ON/OFF, DC ON/OFF and BATTeRy ON/OFF switches OFF and remove the
mAIN POWeR Key when not in use or before long term storage
TROUblEShOOTING
If your Solar Link fails to operate as specified, follow these troubleshooting steps to correct the issue.
If you still experience issues, please contact Aervoe Industries, Inc. at www.aervoe.com or 800-227-
0196.
make sure the mAIN POWeR Key is inserted and ON.
Charging Issues
•
ensure all cords are connected securely
• Check power indicators on chargers and the Solar Link to make sure they are operating
• If using a solar collector to charge, ensure it is correctly positioned in direct sunlight
12V DC Output Failure
•
Check the BATTeRy meTeR to see if the Solar Link has sufficient battery charge available. If not,
follow the charging steps previously described on page 6.
• ensure the DC ON/OFF switch is ON and the green light is ON
• Check to make sure that the 12V DC circuit protection fuse is not blown by removing the 15A
FUSe associated with the suspect 12V DC output plug. Inspect the fuse and replace if needed
with the same size and amperage rated fuse.
• Check the 12V DC outlet for obstructions or other visible damage
• Verify the device being charged is working and not damaged
120V AC Output Failure
•
Check the BATTeRy meTeR to see if the Solar Link has sufficient battery charge available. If not,
follow the charging steps previously described on page 6.
• ensure the INVeRTeR ON/OFF switch is ON and the green LeD is ON
• Check the 120V AC outlet for obstructions or other visible damage
• Verify that the device being powered is working and not damaged
USB Output Failure
•
Check the BATTeRy meTeR to see if the Solar Link has sufficient battery charge available. If not,
follow the charging steps previously described on page 6.
• ensure the DC ON/OFF switch is ON and the green light is ON
• Check the USB port for obstructions or other visible damage
• Verify the device being charged is working and not damaged