Aervoe 1500-Watt Energy Center Buddy User Manual
Page 6
6
Charging
1.
Follow the charging instructions for the #9680 Energy Center 1500.
2.
First turn ON the MAIN POWER SWITCH on the Energy Center 1500 and then on the Energy
Center Buddy.
3.
For maximum efficiency and battery life, fully charge before first use, after each use, and every
30 days during storage.
4.
Disconnect all power sources when not using.
5.
The cooling fan on the Energy Center 1500 will run intermittently during charging to prevent
overheating.
6.
For faster charging, do not use the power output during charging.
•
Dust regularly with a clean dry cloth to prevent dust and dirt from building up on the vents and
power inputs/outputs
•
Store inside in a clean, dry place when not in use. Keep from exposing to extreme cold and hot
environments.
•
Charge after each use and every 30 days when stored so it is ready to use when needed
•
Turn all power switches OFF when not in use and remove the MAIN POWER SWITCH/KEY
If your Energy Center fails to operate as specified, follow these troubleshooting steps to correct the issue. If
you still experience issues, please contact a Product Specialist at Aervoe Industries, Inc. at 800-227-0196
or www.aervoe.com.
Problem: Charging not working
•
If using 120V AC power, confirm the 120V AC POWER CORD is fitted securely in the input port
of the Energy Center 1500 and electrical wall outlet; and that the GFI or circuit breakers have not
been tripped
•
Make sure the MAIN POWER SWITCH is in the ON position of both units prior to charging and
that the CHARGING LED is illuminated under the AC STATUS MONITOR of the Energy Center
1500
•
Verify the 10A AC protection fuse is not broken or missing (located above the 120V charging
input of the Energy Center 1500). Replace with a new fuse if necessary as specified in this
manual.
•
Verify the 12V battery fuse has not faulted (follow instructions in this instruction manual)
•
Check the 12V POWER CHARGE CABLES for damage and replace if needed.
•
If the problem has not cleared up, call Aervoe for further assistance.
The battery and fuse replacement are the only features serviceable by the user. All other repairs must be
performed by Aervoe Industries, Inc. or an authorized repair facility. Failure to follow these guidelines
can damage the unit, cause injury, and voids the product warranty. Call Aervoe and ask to speak with a
product specialist for additional instructions or troubleshooting information.
CHARGING
CARE AND MAINTENANCE
TROUbLESHOOTING
SERVICE AND REPAIR