Adamson Blueprint AV - Manual (Page 23)

Adamson Systems Engineering | Blueprint Training Module Page 23
Section F:
3D Mode Complex Surface Design
5. Create a new surface; select the Extrude surface type
List of Extrude functionalities
⦁ A) No. of Points (Amount of points in given Extrude)
⦁ B) Dir. (Extrude will center on X axis in the direction specified)
⦁ C) Explode (Extrude will separate at each point into individual surfaces)
⦁ D) Dimension (Width of Extrude)
⦁ E) Link buttons (To link Extrude with Revolve surface)