Zilog Z16F2810 - Manual (Page 8)

USB Smart Cable
User Manual
UM018114-0513 USB Smart Cable
5
Programmer for the first time. If you are prompted to connect to Win-
dows Update, click
No, not at this time .
2. Select Install from a list or specific location (Advanced) , then click
Next . If the Windows Logo testing dialog appears, select Continue
Anyway .
3. Select Search for the best driver in these locations and Include
this location in search: , then locate and click the following direc-
tory:
\device drivers\USB\x32
4. Click Next. After the appropriate driver information has been found,
click Next a second time.
5. Click Finish to complete the installation.
Connecting to the Target Board
Observe the following steps to complete the power-on sequence before
connecting to the target.
1. Connect the USB Smart Cable to the host PC.
2. Connect the USB Smart Cable six-pin connector to the target board.
3. Apply power to the target board. If the target is not connected prop-
erly, remove the USB Smart Cable from the host PC and repeat the
preceding steps. If the connection is problematic, refer to the Trouble-
shooting Tips section, which follows on the next page.
4. Attach one end of the six-conductor ribbon cable to the Smart Cable
six-pin DBG connector, as shown in Figure 1. Attach the free end of
the ribbon cable to the connector on the target board. Ensure that pin
1 on the ribbon cable (indicated by the dark stripe) is aligned with pin
1 on the target connector.