WaveWare WiPath PDR-3000 - Manual (Page 12)

supplied. This will normally be noted in the Notes
section.
Invert Decoder Bit Steam Use this if your pager is set to data inverted. Consult
your carrier before using this option.
Set Decoder Baud Rate Use to set the baud rate (pocsag only). This may be set
to auto although better performance may be
experienced if all pagers are on one baud rate and the
unit is set to that baud rate.
Use New Receiver Please consult with Selective before changing this
option. A new receiver is being progressively
introduced from Q3 2005. On the PDT2000 an RSSI
(Received Signal Strength Indicator) will appear on the
display when the new receiver is in use.
Allow decoding errors Selects the number of character errors that the receiver
will accept before it discards (ignores) the message.
Remove leading characters Removes the selected number of leading characters in
a message before it outputs the message or applies any
message filters. This is used to ignore special
characters used by some systems for special decoding
options.
Notes An area to make general notes on this unit. This
information is stored on the PDT/PDR so that it can be
read wherever the unit is programmed.