Denon ASD-51W User Manual

Page 3

SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANCAIS DEUTSCH ENGLISH

FCC Information (For US customers)

1. COMPLIANCE INFORMATION

Product Name: Control Dock for iPod

Model Number: ASD-51W

This product contains FCC ID: PPQ- NM100BB.
This product complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1 ) this product may not cause harmful

interference, and (2) this product must accept any interference received,

including interference that may cause undesired operation.

Denon Electronics (USA), LLC

100 Corporate Drive, Marwah, NJ 07430-2041

Tel. 201-762-6500 (Main)

2. IMPORTANT NOTICE: DO NOT MODIFY THIS PRODUCT

This product, when installed as indicated in the instructions contained in this

manual, meets FCC requirements. Modification not expressly approved by

DENON may void your authority, granted by the FCC, to use the product.

3. CAUTION

• To comply with FCC RF exposure compliance requirement, separation

distance of at least 20 cm must be maintained between the antenna of

this product and all persons.

• This product and its antenna must not be co-located or operating in

conjunction with any other antenna or transmitter.

4. NOTE

This product has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation.

This product generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

product does cause harmful interference to radio or television reception,

which can be determined by turning the product OFF and ON, the user

is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the product into an outlet on a circuit different from that to which

the receiver is connected.

• Consult the local retailer authorized to distribute this type of product or an

experienced radio/TV technician for help.

IC Information (For Canadian customers)

1. PRODUCT

This product contains IC 4491A-NM100BB.

This product complies with RSS-210 of Industry Canada. Operation is

subject to the following two conditions: (1) this product may not cause

harmful interference, and (2) this product must accept any interference

received, including interference that may cause undesired operation.

This Class B digital apparatus complies with Canadian ICES-003.
APPAREIL

Cet appareil contiens IC 4491A-NM100BB.

Cet appareil est conforme à la norme CNR-210 du Canada. L’utilisation de ce

dispositif est autorisée seulement aux deux conditions suivantes : (1) il ne

doit pas produire de brouillage, et (2) l’utilisateur du dispositif doit être prêt

à accepter tout brouillage radioélectrique reçu, même si ce brouillage est

susceptible de compromettre le fonctionnement du dispositif.

Cet appareil numérique de la classe B est conforme à la norme NMB-003

du Canada.

2. CAUTION

To reduce potential radio interference to other users, the antenna type and

its gain should be so chosen that the equivalent isotropically radiated power

(e.i.r.p.) is not more than that permitted for successful communication.

ATTENTION

Afin de réduire le risque d’interférence aux autres utilisateurs, il faut choisir

le type d’antenne et son gain de façon à ce que la puissance isotrope

rayonnée équivalente (p.i.r.e.) ne soit pas supérieure au niveau requis pour

l’obtention d’une communication satisfaisante.

R&TTE Directive 1999/5/EC

This product may be operated in the following countries;