TVLogic LHM-420A - Manual (Page 8)

14 Multi Format LCD Monitor Multi Format LCD Monitor 15
5. Menu Operations
[2] Picture(VGA)
●
Brightness
- This item controls the degree of brightness
between -128 ~ 127.
# Brightness can be adjusted by using the
[Enter] button on the front of the monitor.
●
Contrast
- This item controls the contrast ration
between -128 ~ 127.
# Contrast can be adjusted by using the
[Enter] button on the front of the monitor.
●
Image Position
- This item controls the position(H/V) of the
image in DVI Analog mode.
●
Phase
- This item controls phase value.
# If phase is not set to correct value, image
may display artifacts and out of focus.
●
Clocks/Line
- This item is adjust timing for signal sync.
# If signal sync is not set to correct value,
image may display flickering and drop.
●
Auto Adjustment
- This item adjusts the input signal
automatically. Phase, Clocks/Line, and Image
Position are also adjusted.
# if image doesn’t display correctly after the
Auto Adjustment, select it again for correct
adjustment.
- Auto Adjustment activates automatically
when input signal resolution changes.
5. Menu Operations
[3]Color
●
Color Temp
- This item controls color temperature
and allows instant access to preset color
temperature settings of 3200K, 5600K,
6500K, 9300K and USER 1/2/3.
- In USER1/2/3 mode, user can define custom
RGB GAIN and BIAS values.
●
Gain Red
- This item controls red gain value between
-256 ~ 127.
# Only available in USER1/2/3 mode.
●
Gain Green
- This item controls green gain value between
-256 ~ 127.
# Only available in USER1/2/3 mode.
●
Gain Blue
- This item controls blue gain value between
-256 ~ 127.
# Only available in USER1/2/3 mode.
●
Bias Red
- This item adjusts black level to control red
color between -100 ~ 100 .
# Only available in USER1/2/3 mode.
●
Bias Green
- This item adjusts black level to control green
color between -100 ~ 100.
# Only available in USER1/2/3 mode.
●
Bias Blue
- This item adjusts black level to control blue
color between -100 ~ 100 .
# Only available in USER1/2/3 mode.
●
Color Copy
- This item is used to copy pre-stored color
temperature settings into a USER1/2/3 mode.
- In USER mode, find and select the color
temperature to be used as a starting point of
custom color temperature.
# Only available in USER1/2/3 mode.