TVLogic LHM-420A - Manual (Page 10)

18 Multi Format LCD Monitor Multi Format LCD Monitor 19
6. Other Functions
[1] Video Input
●
LHM monitor is capable of processing all
input signals usable in ANALOG mode.
1. Press [Menu] button on the back of the
monitor for more than 2 seconds and OSD
menu is activated as follows.
Select the desired input by using the [UP]/
[DOWN] button and press the [ENTER]
button to confirm.
2. Input signal information is displayed at the
bottom of OSD menu.
3. Press [Menu] button again to remove the
OSD menu from display.
# If no image displays after selecting the
desired input mode, check and make
sure that your connection is not lose or
disconnected.
6. Other Functions
[2] User Aspect
●
User can change the aspect ratio of
display by using the User Aspect feature.
●
Press the [SCAN] button to activate the
OSD menu as shown above.
●
Press the [ENTER] button to move
between Width and Height.
- Adjust the ratio using the Knob.
- Control range for width :
Min[100] ~ Max[1920]
- Control range for height :
Min[100] ~ Max[1080]
- The size-adjusted picture always stay in the
center of the screen.
# Adjusted image always displays in the
center of the screen.
Example) If user wishes to change 16:9
aspect ratio image to 2.35:1 aspect ratio,
change 1920x1080 resolution to 1920 x 817
by adjusting width and height of the image
in USER ASPECT mode.