Televes High Definition TV Satellite Receiver, zAs HD SAT - Manual (Page 24)

24
High Definition TV Satellite Receiver
11.6. Channels searching
This section describes the steps required for configuring
the installation, the channel searching or maintaining lists
of channels.
Antenna configuration
This menu lets you configure the receiver according to your
installation (simple, DiSEqC, Motor, Unicable).
and keys let you to scroll through the choices.
Select your installation with the keys or . Possible
options are:
None
Your installation is a simple installation, i.e. the receiver is
connected directly to the antenna.
 In “Satellite” option, select the satellite to which the
antenna is oriented.
 The level bars will tell you if you have the satellite
signal and what is the strength and quality for each TV
channel.
 By pressing the yellow key is shown the LNB Setup
submenu, where you can modify the offset of the LNB
(+1 V).
 By pressing the blue key displays the submenu where
you can select Advanced Settings values “ Auto”,1, 2, 3, 4
and 5 for the “Repeat DiSEqC” option.
2 way splitter
If your facility has a monoblock LNB, or a 2 input/port
DiSEqC switch, each one of them connected to dishes
pointing to different satellites.
 Select one of the two ports of the switch in the
“DiSEqC port” option and assign a satellite to
that port on the “Satellite” option. Then select
the other port and assign another satellite.
The level bars will tell you if you have the satellite signal
and what is the strength and quality for each TV channel.
 By pressing the yellow key is shown the LNB Setup
submenu, where you can modify the offset of the LNB
(+1 V).
 By pressing the blue key displays the submenu where
you can select Advanced Settings values “ Auto”,1, 2, 3, 4
and 5 for the “Repeat DiSEqC” option.
4 way splitter
Your installation has a 4 input DiSEqC switch, each
connected to an antenna oriented to different satellites.
It works the same as the 2 inputs.