Televes High Definition TV Satellite Receiver, zAs HD SAT - Manual (Page 10)

10
High Definition TV Satellite Receiver
This screen will indicate if you have a DiSEqC, Motor or
Unicable device in your antenna installation.
If you have a simple installation, ie an antenna connected
directly to the receiver, keep the option “None.”
In paragraph Satellite, you must indicate the satellite your
antenna is pointing.
If your installation does not correspond to this, see. 11.5 .-
Channel search => Antenna Setup.
 Select one of these options using the cursor keys or
, and in each one, change the value using the cursor keys
or .
The level bars will show you if you have satellite signal and
what is the strength and quality for each TV channel.
Before you start a channel scanning, you must specify the
requirements of the search.
 In Scan Mode, indicate if you want to search: All channels
(“All”) or free-to-air channels (“Free Only”).
 In Channel Type, indicate the type of channels you
are searching for: only “TV” , only “Radio” or both “TV &
Radio”.
 Indicate if the search is going to be performed across
the entire network, “Yes”, or only on transponders stored
in the receiver, “No”.
 Press OK to confirm the settings and continue.
The automatic channel searching starts.
This process may take some time. Please wait.
 You can stop the search at any time by pressing OK.
Finally, a summary of the channels found is displayed.
 Press OK to continue. Press again this key to start
viewing the channels found.
- If the receiver was not able to found any
channels at the end of the searching, a warning
message will appear. Press OK to continue.
Check connections, press OK to perform another
searching or modify any parameter. (For more
information, see par. 11.5. Channels searching
=> Antenna Setup).