Signamax 5-Port 10/100BaseT/TX PoE Switch with 4 PoE Ports & 1 100BaseFX Port - Manual (Page 4)

电 ⼒线
POW+DATA
DATA
User Guide:
1. Check the PoE switch:
1. Please check the enclosure, the RJ-45 ports, and the LED
indicators, making sure they are ok.
2. Connect the PoE switch to AC power, making sure the
initialization of the PoE switch occurs as below:
• POE indicator is off when power is connected.
• POW indicator is on and remains on after connection
to AC power.
• Other indicators will be on, then off after one or two
seconds.
2. Cable connection:
1. Connect the Switch to Computer or other PD (such as an IP
camera or wireless AP) by Cat. 5 or better cables.
2. Connect the external power cord to the Switch and the
power cord to AC plug
3. Turn on the switch
Caution:
1) All operation should be provided only by a qualified service
technician.
2) Make sure the PDs you connected to the Switch are
compliant with IEEE 802.3af or 802.3at.
3) Make sure the power is off before unplugging the AC power.
4) Makes sure all PoE PDs power consumption is less than
total power
5) Please avoid any heavy thing placed on the Switch.
6) Do not use this product near water, for example, in a wet
basement or near a swimming pool.
7) Avoid using this product during an electrical storm. There
may be a remote risk of electric shock from lightning.
8) For outdoor use, the Switch itself should be housed inside a
protective enclosure.
9) Cutting power during a firmware upgrade can damage your
device.
10) Only use attachments/accessories specified by the
manufacturer.
11) Opening the switch or tampering with the warranty sticker
can void your warranty.